Matek XCLASS PDB 8-60v FCHUB-12S V2

Matek XCLASS PDB 8-60v FCHUB-12S V2Are you wanting to buy the Matek XCLASS PDB 8 60v FCHUB 12S V2 in Australia? The Matek XCLASS PDB 8 60v FCHUB 12S was designed to connect all your drone electronics together with maximum efficiency. This PDB distributes power from a 2~6S LiPo pack to 4 ESCs, as well as providing regulated & filtered BEC 5V 6A outputs for powering Cameras, RC receiver, Flight Controllers, LEDs, etc. This board is one of the leaders of the market where durability is

Are you wanting to buy the Matek XCLASS PDB 8-60v FCHUB-12S V2 in Australia?

The Matek XCLASS PDB 8-60v FCHUB-12S was designed to connect all your drone electronics together with maximum efficiency.
This PDB distributes power from a 2~6S LiPo pack to 4 ESCs, as well as providing regulated & filtered BEC 5V/6A outputs for powering Cameras, RC receiver, Flight Controllers, LEDs, etc.
This board is one of the leaders of the market where durability is concerned. 

Quick Start Guide  (PDF)

PDB

• Input voltage range: 8~60V (3~12S LiPo)
• 4x70A cont, 4x110A burst
• 4x ESC power /signal/ telemetry pads
• Current Senor: 440A,  3.3V ADC,  Scale 75
• 2x LED indicators for 5V, 12V
• 1K:20K voltage divider built-in

JST-SH 8pin connector

• “V” pad: 12V or VBat voltage selectable
• G: GND
• Curr: current sensor signal
• TLM: for BlHeli32 ESC telemetry
• S1~S4: ESC signal

BEC 5V output (5V pad)

• Voltage: 5.1 +/- 0.1VDC
• Continuous current 5 Amps,  Max.6A
• Short-circuit tolerant (2 seconds)
• Overcurrent protection & self-recovery

BEC 12V output (12V pad)

• Voltage: 12.0 +/- 0.2VDC (Input voltage >=12V)
• Continuous current 4 Amps,  Max.5A
• Input voltage<12V,  Output voltage = Input voltage
• Short-circuit tolerant (2 seconds)
• Overcurrent protection & self-recovery

Switchable 12V output (12VSW pad)

• 12V ON/OFF switchable via PINIO(high/low level)
• support constant 2A
• can be use for powering VTX,LED etc.

BEC 3.3V output

• Linear Regulator
• Continuous current: 500mA

Physical

• Mounting: 30.5 x 30.5mm, Φ3mm
• Dimensions: 55 x 50 x 6 mm
• Weight: 21g

Including

• 1x FCHUB-12S V2
• 1x SH1.0_8pin cable 5cm,  2x SH1.0_8pin connectors

BROWSE MORE

Browse all MATEK
Browse all FC's 
Browse all DRONE ELECTRONICS